imap_mail_copy

(PHP 4, PHP 5, PHP 7)

imap_mail_copy — Copy specified messages to a mailbox

说明

bool imap_mail_copy ( resource $imap_stream , string $msglist , string $mailbox [, int $options = 0 ] )

Copies mail messages specified by msglist to specified mailbox.

参数

imap_stream

由 imap_open() 返回的 IMAP 流。

msglist

msglist is a range not just message numbers (as described in » RFC2060).

mailbox

The mailbox name, see imap_open() for more information

options

options is a bitmask of one or more of

CP_UID - the sequence numbers contain UIDS
CP_MOVE - Delete the messages from the current mailbox after copying

返回值

成功时返回 TRUE ，或者在失败时返回 FALSE 。

参见

imap_mail_move() - Move specified messages to a mailbox

用户评论:

[#1] jigar dot dhaduk79 at gmail dot com [2015-09-29 11:11:18]

When we want to copy more than one mail, we can write '(string)' before msg_num. Like..

$msg_num = "1,2,3,4,5,6,7";
$copy = imap_mail_copy($imap_stream, (string) $msg_num, '[Gmail]/Important', CP_UID);

[#2] Ben [2013-01-26 13:18:22]

If you use this function and you get the following notice:

Notice: Unknown: IMAP protocol error: Could not parse command (errflg=2) in Unknown on line 0

Notice: Unknown: Could not parse command (errflg=2) in Unknown on line 0

you should check the function parameters. This notice appears (according to what I found on the internet and my problems) when it gets an invalid $msglist. So be sure to give the right number (as a String!):
"$msg_num", $msg_num or (string) $msg_num.

Dont use '$msg_num' when calling the function, this will literally send the string $msg_num.
You can give a string like "1,3,5,7,8", which will work perfectly fine to move the given mails.

I had all my mailnumbers in an array ( $messageSet) and used

<?php $messageSetImpl = implode ( "," , $messageSet ); imap_mail_copy( $imapStream, $messageSetImpl, $mailBox ) ?>

What I hadn't had thougt of was that my $messageSet was sometimes empty, that was when I got the notice. So you might want to check that by putting first:

<?php if ( !( empty( $messageSet ) ) ) { $messageSetImpl = implode ( "," , $messageSet ); imap_mail_copy( $imapStream, $messageSetImpl, $mailBox ) } ?>

That should work.

[#3] richard dot oplustil at gmail dot com [2012-03-26 15:18:41]

imap_ mail_ move and imap_mail_copy don't work with sequence numbers on MS Exchange. imap_ uid in combination with CP_UID works fine.

[#4] marcus at names dot co dot uk [2002-07-08 10:51:40]

If you are having problems getting imap_mail_copy and imap_mail_move to work, check you have installed imap_devel (the imap development libraries) as well as imap (the imap daemon). Without it, PHP appears to configure correctly --with-imap, but some functions do not work.

It took me about 12 hours to figure this out!!

[#5] hxlvt at hotmail dot com [2001-01-04 16:37:35]

After much fooling around, imap_mail_copy did work for me. One thing you might want to check, if you are having problems, is the new mailbox name. Make sure it is just a folder name, e.g. INBOX.haha without the server part.