Tutorial on how to annotate pipe fittings in Revit using annotation scale

In Revit software, accurate dimensioning of pipe annotation scale is critical. This guide by php editor Xigua will provide step-by-step instructions to help you master the operation method of marking pipe annotation proportions in Revit. This article walks you through the steps of doing this, from configuring view settings to adding annotations to ensure you can accurately and efficiently represent fitting dimensions in your Revit model.

1. The role of annotation scale

You can see below that we used some elbows and tees downloaded from the Internet. The sizes are inconsistent in the single-line view and are obviously too small

In fact, the solution is very simple. Just check [Use Annotation Proportion] to make it display an equal proportion of size

Note: Due to the annotation The scale is an instance parameter. It should be set as early as possible in the early stages of modeling. Otherwise, it needs to be adjusted one by one. Of course, we can also select all instances in the project list or view to set them in batches

2. Annotate the proportional size

Now the sizes of all our pipe fittings are basically the same, but they are still found to be too small

At this time we can go to [Management] >Adjust under [Mechanical Settings]

Adjust the annotation size of the pipe fittings. In addition, the pipe raising/lowering annotation size can modify the two-dimensional size of the riser or pipe section in our plane

In this way, the size of our overall pipe fittings will be very standard and beautiful

Note: Since this is the absolute printing size in mm, it will be affected by The current view's scale affects.

Note that this method of modifying the family category can make it appear in the corresponding family category. However, if the appropriate family template is not selected at the beginning of creation, even if the family category is modified, It is still possible that the family does not have the correct family functions, in which case the only option is to select a suitable family template for reconstruction.

The above is the detailed content of Tutorial on how to annotate pipe fittings in Revit using annotation scale. For more information, please follow other related articles on the PHP Chinese website!