SWFObject 2.1 or above version syntax introduction_javascript skills

However, the previous calling method is a bit cumbersome. First instantiate -> add parameters and variables -> write, which is as troublesome as putting an elephant in the refrigerator. Fortunately, the author finally noticed this. In the new 2. Everywhere, it can be seen that human beings' technological level is advancing rapidly. Let's list some of the most commonly used call examples in our daily development.

1. The simplest and most basic, a classic sentence that can be used as long as you want to insert flash

Copy the code The code is as follows:

Note: Call method embedSWF - insert SWF file, the parameters are
@The address of the swf file;
@Container (such as div) used to load swf files id;
Width of @flash;
Height of @flash (of course, the width and height here can be expressed by percentages such as 100%);
@Minimum required to play the flash normally Version;
@When the version is lower than the requirement, execute the swf file, and use this flash to jump to the official download of the latest version of the flash plug-in. (This parameter can be omitted)

When inserting multiple flashes into different locations on the same page, just repeat the above statement and use different container IDs.

2. Calling method to pass parameters, variables and attributes to swf file

Copy code The code is as follows:

Finally, the embedSWF method is called to embed flash. The order of parameters is also very clear. I prefer the calling method in the first one. It is not tiring to watch and easy to use. convenient.
Package download address