Is the computer stuck in the settings interface when starting up?

When the computer is turned on, it is stuck in the settings interface and cannot continue to run, which is very disturbing. This problem can be caused by a variety of reasons, such as hardware failure, software conflicts, or system corruption. PHP editor Xigua will introduce to you the common reasons and solutions for computer startup stuck in the settings interface. By understanding these issues and taking appropriate measures, you can quickly restore your computer to normal operation.

The computer is stuck in the settings interface when it is turned on?

Problem analysis: The computer is stuck on the motherboard interface when it is turned on. This generally means that there is a problem with the computer and it failed to pass the power-on self-test. Solution:

1. If the motherboard LOGO cannot be entered when the system is turned on, you need to restart and press the TAB key to skip the LOGO screen or press the DEL key (F2 or other for notebooks) when turning on the computer to enter the CMOS setting interface. In the Advanced BIOS Turn off Full Screen LOGO Show in the Features tab to see if the power-on self-test information can be displayed, and then take a screenshot to determine the problem.

2. Under normal circumstances, you can press the F1 key to skip non-fatal errors and directly start the computer according to the black screen and white text prompts, or press the DEL key to enter CMOS, and then press F9 to load predefined parameters or select Load Optimized Defaults (load high-performance defaults) or Load Fail-Safe Defaults (load fail-safe defaults), and then press F10 to save, exit and restart.

3. If it is invalid, it means there is a problem with the hardware. Generally, the memory and hard disk may have poor contact or damage and need to be replugged or replaced.

My computer is stuck in the motherboard settings interface when I turn it on and cannot enter the system. What should I do?

In this case, if there is no problem in the bare-board test, the biggest hidden danger is that the wiring is not plugged in properly. For example, if the boot is normal and the restart is normal, but the motherboard does not enter the system at this time, it means that there is a wiring problem. Check the traffic lights on the front panel of the chassis. If the two lights are not on, it means that the protection has started and the page is stuck. At this time, shut down the computer and quickly unplug the pair of green and white wires, which are the separate POWER LED - wires. Troubleshooting. Many players are too careless when installing the computer, thinking that after plugging in the cables and turning on the computer, it will boot and restart, even if the installation is completed. In fact, if this happens during startup, it means that you have not completed the cable installation, because the traffic light on the front panel of the chassis may not respond. Once the POUER LED cable is plugged in incorrectly, the page will freeze. In fact, if you pay careful attention, the glitch usually only occurs during packing. I have tested it N times. Of course, the motherboard runs without problems during bare-metal startup. I unplug the red and green wires at the shutdown speed and plug them back in order. The problem is solved.

The above is the detailed content of Is the computer stuck in the settings interface when starting up?. For more information, please follow other related articles on the PHP Chinese website!