Home >Computer Tutorials >Computer Knowledge >The router has no data connection after setting up the WAN port.

The router has no data connection after setting up the WAN port.

王林
王林forward
2024-01-25 09:39:151680browse

The router has no data connection after setting up the WAN port.

There is no data on the wan port after setting up the router

1. Possible reasons: Wrong connection of the line or poor contact of the network cable interface.

Solution: Confirm that the main line is plugged into the WAN port of the router.

2. Possible reasons: The home network cable is aging, of poor quality, or the line is too long, resulting in excessive line attenuation.

Solution: Try adjusting the rate mode of the router’s WAN port. Enter the router management interface, find the advanced settings option, and then click Network Parameters and WAN Port Settings. In the WAN port speed setting, select 10Mbps half-duplex or 10Mbps full-duplex mode, and finally click the Connect button.

Note: Some routers or some software versions do not support adjusting the WAN port rate mode. Try upgrading the router software version.

3. Possible reasons: The modem is not powered on or the line is faulty.

Solution: Test the direct connection to the broadband and check whether you can access the Internet normally to eliminate problems with the broadband line or the modem.

4, possible reason: The WAN port of the router is broken.

Solution: Connect both ends of a network cable to the WAN port and one of the LAN ports. If the WAN port indicator still does not light up, the router's WAN port may be faulty. Please check whether the power specifications of the power adapter match the power specifications on the label on the bottom of the router. If there is a match, please contact the office for further testing and repair.

The WAN port of the router has been unable to receive data

Is there any problem with the network cable of the WAN port?

1. The broadband network bus is connected to the WAN port of the router, and the LAN port of the router is connected to the computer.

2. After starting the device, open the browser and enter 192.168.1.1 in the address bar to enter the wireless router setting interface. (If you cannot enter, please read the nameplate on the bottom of the router or the router instruction manual. Different router models have different default settings.)

3. An account and password for logging into the router will appear on the setting interface. Enter the default account and password admin, or refer to the manual;

4. After successful login, select the setup wizard interface, which will pop up automatically by default;

5. After selecting the setup wizard, a window will pop up explaining that you can set the basic parameters of the router through the wizard. Just click Next;

6. Set up step by step according to the setup wizard and select the Internet access method. Usually ADSL users choose the first item PPPoE. If you are using other network service providers, choose the following two items according to the actual situation. If you don’t know how to choose If so, just select the first item and it will be selected automatically, which is convenient for novices to operate. After selecting, click Next;

7. Enter the account number and password you applied for from the network service provider. After completing the input, go to the next step;

8. Set the wifi password, and try to make the combination of letters and numbers more complex to prevent it from being used on the Internet.

9. After the input is correct, you will be prompted whether to restart the router. Select Yes to confirm to restart the router. After restarting the router, you can access the Internet normally.

The above is the detailed content of The router has no data connection after setting up the WAN port.. For more information, please follow other related articles on the PHP Chinese website!

Statement:
This article is reproduced at:docexcel.net. If there is any infringement, please contact admin@php.cn delete