Sanyo xqb65-s808 washing machine ec failure?

EC failure in the washing machine is a headache. In this article, PHP editor Apple will provide you with the analysis and solutions to EC failures in washing machines. The article will analyze the cause of the fault in a simple and in-depth manner and provide detailed repair steps to help you easily troubleshoot and solve the EC fault of the washing machine. If you want to know more about washing machine EC failures, come and read the text!

Sanyo xqb65-s808 washing machine ec failure?

Sanyo washing machine EC error code is fuzzy motor no feedback.

Solution:

1. The triac on the motor drive circuit is damaged due to short circuit or breakdown between the collector and emitter of the transistor. The fault can be eliminated by replacing the damaged parts.

2. If the connector is loose or the relevant circuit components are soldered, just check and repair or replace the relevant parts.

3. Check whether the computer board is damaged.

How to remove the computer board of Sanyo XQB60-M808 washing machine? Thank you?

The computer board of Sanyo XQB60-M808 washing machine is broken. Replacement steps:

1: Use a screwdriver to remove the panel.

2: See the PC version.

3: Remove the panel plug-in.

4: Remove the panel.

5: Install new panels.

6: Plug in the plug-in.

7: Install the outer cover.

How to change the motherboard of Sanyo washing machine xqb60-s808?

Sanyo fully automatic washing machine computer board replacement method:

1, remove the panel.

2. Remove the plug-in of the computer board.

3. Remove the screws from the computer board.

4. Take off the computer board and replace it with a new one.

5. Connect the plug-in, install the panel and tighten the screws.

1

Removing the impeller: Loosen and take out the screw in the middle of the impeller and the impeller gasket, then take out the impeller and the impeller gasket.

2

Removing the inner barrel: First remove the 2 fastening screws at the rear and the 2 fastening screws at the front and left; then slowly open the upper panel and remove the 4 fastenings of the outer barrel ring screws, you can remove the outer barrel ring; remove the impeller as mentioned above, take out the four hexagonal screws below, and then slowly try to lift out the inner barrel with a little force.

3

Removing the washing machine clutch: After removing the pulsator and inner barrel, remove the clutch. After removing all the fixing screws of the clutch, you can disassemble the clutch. Stand the washing machine up and knock the thin shaft of the clutch in the middle of the dehydration barrel hard. The clutch and the dehydration barrel have formed a tight fit and are very strong. First, carefully clean the surrounding scale and garbage. You can also spray a little rust loosening agent. Then find a suitable wooden stick to hold against the thin shaft in the middle of the clutch and use a hammer to force it. Knock the clutch off the washtub.

The above is the detailed content of Sanyo xqb65-s808 washing machine ec failure?. For more information, please follow other related articles on the PHP Chinese website!