Computer with dual memory sticks keeps restarting

The computer configuration is as shown in the figure. I plan to install a same memory stick and then dual-pass it, but the result is an infinite restart.

First check to use 1 memory stick inserted in different slots Is there any problem inside. This can determine whether the problem lies with the motherboard or the memory. If there is no problem with all accessories, clean the bios, unplug the motherboard battery for 10 seconds and then put it back again. Restart and reset.

You can use 1G 512M at the same time. If it is old, it may be refurbished. You can check the anti-counterfeiting on the official website to find out. The memory must be inserted, and the slots are in no particular order. The memory is too small and not enough. There is no need to set it in the BIOS.

Cause of viruses. Use Computer Manager to remove viruses. memory reasons. Use an eraser to wipe the gold finger of the memory module to remove the oxide layer to ensure that the memory module is installed and operating normally.

For hardware compatibility issues, you can directly go to a computer repair shop and reconfigure a memory module according to your configuration.

Yes, there must be some compatibility issues, after all, the memory particle parameters are different. It is recommended to clean the golden fingers, memory slots and CPU pins to prevent problems caused by poor contacts. At the same time, updating the motherboard's BIOS can also solve compatibility issues.

What to do if the computer automatically restarts after adding a memory module

1. If all accessories are fine, clean the bios, unplug the motherboard battery for 10 seconds and then put it back. Restart and reset.

2. First, turn on the computer, find the "del" key on the keyboard, and then press the "del" key to enter the BIOS page, as shown in the figure below, and then proceed to the next step. Secondly, after completing the above steps, find the "EXIT" option and click to enter, as shown in the figure below, and then proceed to the next step.

3. Use a single memory stick to test, and the restart phenomenon will be solved. The main reasons why the computer restarts frequently are as follows: the filter capacitor (3300uf3V) next to the CPU on the motherboard leaks seriously, the host power supply cannot withstand it, and the CPU power supply is insufficient, so the computer is restarted to protect itself.

Why does the computer always restart automatically after inserting two memory sticks? If you remove one, it will be fine.

1. Reason: The memory stick is not inserted properly or there is dust on the gold finger. The computer cannot be turned on due to incompatible memory modules. Method: Use an alcohol cotton ball to wipe the memory for a while. Use an alcohol swab to clean the memory slots as well. The graphics card slots are wiped with alcohol cotton balls. During the wiping process, the motherboard battery can be discharged.

2. The motherboard is incompatible with the memory module or the memory module is of poor quality. It is common when high-frequency memory is used on some motherboards that do not support this frequency memory module. You can try to reduce the memory in the CMOS settings. Check the reading speed to see if the problem can be solved. If not, the only option is to replace the memory module.

3. There are several reasons: two memories conflict and are not of the same type. There is a problem with the memory slot on the motherboard. There may be too much dust causing poor contact. The memory itself has been used for too long, and the golden fingers are over-oxidized, causing poor contact; you can pull it out and wipe it clean before trying to use it again. The memory is inserted backwards.

4. Memory incompatibility. Try using only one of them. If both are fine when used alone, it means they are not compatible. If there is a problem with one of them, just unplug the problematic one. Motherboard memory slot problem. This problem often occurs with motherboard memory slots.

5. Solution: The motherboard is incompatible with the memory module or the memory module is of poor quality. It is common in high-frequency memory used on some motherboards that do not support this frequency memory module. You can try to set the CMOS settings. Reduce the memory reading speed to see if the problem can be solved. If not, the only option is to replace the memory module.

The above is the detailed content of Computer with dual memory sticks keeps restarting. For more information, please follow other related articles on the PHP Chinese website!