Sometimes everyone encounters the need to manually modify the IP address, but some Windows 10 customers report that the IP address cannot be saved after setting it. How to solve this situation? The IP address is stored basically because there is an error in filling in your IP address. You can check whether the subnet prefix has been written with the subnet mask. If so, change it back. After the change, you can save it normally. IP address.
How to solve the problem that the Windows 10 IP address cannot be saved after it is set:
The error picture is as follows: The prompt "Unable to save the IP setting, please check one or more settings and try" is caused by filling in the error, here It is the subnet prefix length, not the subnet mask, as shown in the figure.
#As shown in the picture above, many users actually write the subnet mask out of the subnet prefix. The subnet prefix length is 24 bits, so the corresponding subnet mask is 255.255.255.0.
##In other ways to manually set the IP, you can also go to the Control Panel>Network and Internet>Network and Sharing Center>Active Networks>Local Area Connection>Click Network Connections >Features> Double-click to enter Internet Protocol Version 4> Select "Apply the following IP address" to manually set the IP. The above is an introduction to how to solve the problem that the Windows 10 IP address cannot be saved after it is set.The above is the detailed content of How to solve the problem that Windows 10 IP address cannot be saved after setting it. For more information, please follow other related articles on the PHP Chinese website!