Home >Common Problem >How to check the ip address of wsl2

How to check the ip address of wsl2

DDD
DDDOriginal
2024-08-14 16:03:191543browse

This article provides instructions on how to check, change, and verify the IP address assigned to Windows Subsystem for Linux 2 (WSL2). The focus is on obtaining the IP address using the "ifconfig" command, editing the network configuration

How to check the ip address of wsl2

How to Check the IP Address of WSL2

To check the IP address of WSL2, open a command prompt in WSL2 and run the following command:

<code>ifconfig eth0</code>

The IP address will be displayed in the output of the command.

How to Change the IP Address of WSL2

To change the IP address of WSL2, you need to edit the network configuration file. The steps to do this are as follows:

  1. Open the network configuration file in a text editor. The location of the file is:
<code>/etc/wsl.conf</code>
  1. Find the line that starts with [network], and add the following lines to the file:[network], and add the following lines to the file:
<code>[network]
interface = eth0
address = 192.168.1.100
netmask = 255.255.255.0
gateway = 192.168.1.1</code>
  1. Replace the IP address, netmask, and gateway with the desired values.
  2. Save the file and close the text editor.
  3. Restart WSL2 by running the following command:
<code>wsl --shutdown</code>

How to Determine Whether WSL2 Has Been Assigned an IP Address

To determine whether WSL2 has been assigned an IP address, open a command prompt in WSL2 and run the following command:

<code>ip addr show eth0</code>

If WSL2 has been assigned an IP address, the output of the command will include a line that starts with inet

rrreee
    🎜Replace the IP address, netmask, and gateway with the desired values.🎜🎜Save the file and close the text editor.🎜🎜Restart WSL2 by running the following command:🎜🎜rrreee🎜How to Determine Whether WSL2 Has Been Assigned an IP Address🎜🎜To determine whether WSL2 has been assigned an IP address, open a command prompt in WSL2 and run the following command:🎜rrreee🎜If WSL2 has been assigned an IP address, the output of the command will include a line that starts with inet.🎜

The above is the detailed content of How to check the ip address of wsl2. For more information, please follow other related articles on the PHP Chinese website!

Statement:
The content of this article is voluntarily contributed by netizens, and the copyright belongs to the original author. This site does not assume corresponding legal responsibility. If you find any content suspected of plagiarism or infringement, please contact admin@php.cn
Previous article:How to activate xmindNext article:How to activate xmind